OpenStreetMap
Mapping buildings with roofs at different levels from awkward angles
Апублікавана карыстальнікам Horza 9 Люты 2018 на мове English Апошняе абнаўленне 10 Люты 2018.This building can only be seen in the Esri imagery and that is from an awkward angle. How do I mark out the outline of this building accurately?
Edit: Building at 53.46, -2.23. Corner of Burleigh Street and Denmark Road
2nd Edit. Guess I should have mentioned. The east half of the building is taller than the west half. That’s where the problem is. Sorry.
Абмеркаванне
Каментар ад Glassman у 9 Люты 2018 у 20:55
Best practice would be to map the roof line accurately then move the outline to match what you can see where the building sits on the ground.
Каментар ад andy mackey у 9 Люты 2018 у 21:25
Have you looked here osm.wiki/Roof_modelling
Каментар ад Horza у 10 Люты 2018 у 12:02
Andy: Yes, this is the relevant bit osm.wiki/Roof_modelling#Modelling_of_outlines_of_building_with_different_heights
That only works if you can see where the two different sections of roof meet though.
Glassman: That’s what I’d usually do, but the west half of the building is about half the height of the east half, which I guess I should have mentioned in the diary, anyway…
I’ve used that to get an approximate mapping for now. I mapped the east half of the building, moved it halfway down, then mapped the west, then moved it the rest of the way to the ground. I go near here occasionally so I’ll take a small diversion and count floors at some point.